Kärcher MC 130 Classic Bedienungsanleitung Seite 86

Waste container
Attaching the waste container
DANGER
Risk of crushing when lowering/raising the waste container
Maintain sufficient clearance to the waste container and the roll-
ers on the parking supports.
Maintain sufficient clearance to hazard zone and stop raising/
lowering immediately when a person enters the hazard zone.
ATTENTION
Risk of injury and damage
The dirt receptacle and fresh water tank are empty.
Remove the waste container only on a level and smooth surface.
Front parking support
1
Rear parking support
2
Lever for securing the parking supports
3
Retaining clip
4
1. The waste container must be secured on the parking supports
for installation.
2. Set the switchover valve to the attachment frame position.
3. Drive the rear of the vehicle carefully under the waste contain-
er.
4. Raise the attachment frame slowly until under the waste con-
tainer.
Hooks
1
Attachment frame
2
5. Hook the waste container onto the attachment frame using the
retaining hooks.
86
6. Continue raising the attachment frame until the load on the
front parking supports is relieved.
a Lift the attachment frame only until the rollers of the front
parking supports are approx. 20 mm in the air.
7. Pull out the front parking supports. For this, pull the retainer to
unlock and then press the lever.
8. Completely lower the attachment frame together with the
waste container.
9. Pull out the rear parking supports. For this, pull the retainer to
unlock and then press the lever.
Waste container
1
Retaining pins
2
Locking pin
3
Frame
4
Hydraulic connection
5
10.Push the retaining pin the of waste container in and secure
with the locking pin.
11.Connect electrical and hydraulic connections.
Water connections
1
12.Turn the steering wheel all the way to the right to provide bet-
ter access to the connections on the articulated joint.
13.Connect the water recycling hose.
14.Connect the fresh water hose.
15.Connect the high-pressure cleaner hose (optional).
English