Kärcher MC 130 Classic Bedienungsanleitung Seite 94

Operation
Control assignments for a vacuum sweeper with a front
brush sweeper system
Note
The indicators in the switches light when the switches are
switched on.
Left joystick for controlling the front brush
1
– Joystick forwards: Front brush lowers and switches on
Note
Increase the contact pressure in the case of heavy soiling
– Joystick backwards: Front brush raises and switches off
– Joystick to the left/right: Front brush moves to the left/right
Right joystick for controlling the sweeping brush
2
– Joystick forwards: Lower the brush arms simultaneously
and switch on the side brushes
– Joystick backwards: Raise the brush arms simultaneously
and switch off the side brushes
– Joystick to the left/right: Pivot the brush arms simultaneous-
ly
Raise/lower suction mouth
3
Hydraulic system on/off
4
Front brush rotation direction reversal
5
When activated: Tilt/roll the front brush with the right joystick
6
Water circulation function on/off (recycling water)
7
Suction fan on/off
8
ECO function
9
Water pump on/off
10
(A) Front brush rotary speed selection
(B) Sweeping brush rotary speed selection
(C) Engine speed
Press to adjust the values
Note
The suction power depends on the set engine speed.
● 1600 rpm light waste
● 2200 rpm normal soiling
● 2500 rpm strong, heavy soiling
(D) Sweeping brush load relief
(E) Front brush load relief/pressure
(F) Save button
Press to save adjusted values or programs
(G) Rotary knob
Press to change the adjusted values
94
A green bar in the display indicates a reduction in the brush con-
tact pressure.
A red bar indicates an increase in the brush contact pressure.
The front brush must be secured in the desired position when us-
ing the device as a weed brush.
Three positions are possible.
Travel direction
1
Right position
2
Front position
3
Left position
4
1. Secure the desired working position with bolts and spring pins.
See chapter Transport lock.
2. Press the Change of rotation direction button when working in
the Left position.
The front brush must be secured when driving on public roads
(transport journeys).
Bolt
1
Spring pin
2
1. Move the front brush carriage all the way to the left.
2. Secure the front brush in the corresponding position using a
pin and spring pin.
Further information can be found in the operating instructions for
the vehicle.
Maintenance and care of the sweeping unit
1 Check the front brush and sweeping brush for tangled cords
and straps and remove as necessary.
2 Keep the hydraulic connections clean and check for leaks
once a week.
3 Check the front brush and sweeping brush for wear and tear
and replace if necessary.
English
Brush contact pressure
Using the weed brush
Transport lock
Care work