Front Power Lift (Option) - Kärcher MC 130 Classic Bedienungsanleitung

8. Depressurise the hydraulic system. See chapter Depressur-
ise the hydraulic system (pressure relief).
9. Set the ignition to position 1 in working mode (do not start the
engine).
The brushes lower and the hydraulic system depressurises.
10.Disconnect all connections and joints.
11.Remove the suction hose between the waste container and
suction mouth.
12.Disconnect the (thick) water hose.
13.Move the sweeper system out using the lift truck.
Storage box
1
Cables and hoses
2
14.Place the cables and hoses in the storage boxes.
15.Park the sweeper system in a safe place.
16.Extend the lift truck.
Installing the sweeping system
Signal plug for attachment device detection
1
Left side brush connections (hydraulics and water)
2
Sweeping system lock
3
Right side brush connections (hydraulics and water)
4
1. Stop the vehicle on level, solid ground and secure it against
rolling away.
2. Attach the sweeper system to the vehicle in the reverse se-
quence.
3. Lock the sweeper system (lever down).
4. Check the locking, see chapter Checking adjusting the attach-
ment locking mechanism.
5. Depressurise the hydraulic system. See chapter Depressur-
ise the hydraulic system (pressure relief).
6. Connect the hydraulic hoses to the couplings.

Front power lift (option)

Various different attachment devices can be attached to the front
power lifter using a 3-point mounting.
A changing carriage is required for attaching/removing the front
power lift.
Note
Optional accessory, order no. 2.852-067.0.
Installing the front power lift
1. Stop the vehicle on level, solid ground and secure it against
rolling away.
Locking lever
1
Vehicle mounting frame
2
Front power lift mounting
3
2. Move the locking lever upwards.
3. Use the lift truck to position the front power lift centrally in front
of the vehicle.
4. Insert the front power lift into the mounting frame on the vehi-
cle, all the way to the end stop.
English 89