Preparing For Maintenance Work - Kärcher MC 130 Classic Bedienungsanleitung

ATTENTION
Malfunctions
Keep the V-belt clean and free of grease.
1 Use high-grade multi-purpose grease.
2 Lubricate the grease nipples in accordance with the lubricating
intervals (Table) using a grease gun.
Sweeping system lubrication plan
Lubrication point
1 Brush head lifting arm axle
2 Cylinder lifting arm axle
3 Swivel bearing lifting arm axle
4 Swivel bearing cylinder axle
ATTENTION
Malfunctions
Keep the V-belt clean and free of grease.
1 Use high-grade multi-purpose grease.
2 Lubricate the grease nipples in accordance with the lubricating
intervals (Table) using a grease gun.
Lubrication point
1 Swivelling cylinder lifting arm axle
2 Swivel bearing base support axle
3 Suction mouth cylinder support
4 Suction mouth cylinder basic body
5 Swivelling cylinder base support axle 1
6 Swivelling cylinder base support axle 1
1. Park the vehicle on a level surface.
2. Switch off the suction fan.
3. Lower the side brushes.
4. Apply the parking brake.
5. Secure the vehicle against rolling away.
6. Switch off the ignition and remove the ignition key.
Risk of fatal injury from flowing road traffic
Bring the vehicle out of the hazard zone of flowing road traffic be-
fore starting any repair work.
Switch on the warning flashers.
Erect a warning triangle.
Don warning clothing.
Risk of injury and damage
Engine continues to run after switch-off.
Wait 5 seconds after switching off the engine.
Be sure to keep away from the working area during this period.
Risk of damage through incorrect cleaning
Number Lubrica-
The articulated joint, tyres, radiator fins, hydraulic hoses and
of lubri- tion inter-
valves, seals, electrical and electronic components must not be
cation val
cleaned using a high-pressure cleaner.
points
Observe the respective safety regulations when cleaning the ve-
hicle with a high-pressure cleaner.
1 each Every 8 h
Do not use aggressive cleaning agents.
1 each Every 8 h
Wash the vehicle only when the engine is switched off to protect
1 each Every 8 h
the air filter.
1 each Every 8 h
Risk of injury and damage
The vehicle may start up unexpectedly.
Always remove the ignition key and disconnect the battery before
performing any maintenance or cleaning work.
Risk of injury and damage
Maintenance work on the hydraulic system may only be per-
formed by specially trained personnel.
Risk of injury and damage
Always secure the tipping mechanism.
Danger of injury
Fully tip the waste container and lower the brush system/attach-
ment unit to relieve the hydraulic system of pressure during all
maintenance work.
The waste container can pivot to the rear. Always completely low-
er the waste container to the end position before performing work
underneath the waste container.
The waste container can lower unintentionally. Perform work on
the turbine only when the waste container is fully raised.
Number Lubrica-
Danger of burns
of lubri- tion inter-
Allow the vehicle to cool down sufficiently.
cation val
Do not touch any hot components of the hydraulic system, hydro-
points
static drive motor, internal combustion engine or the exhaust sys-
1 each Every 8 h
tem.
1 each Every 8 h
ATTENTION
Environmental pollution
1 Every 8 h
Do not allow fluids such as engine oil, hydraulic oil, brake fluid,
1 Every 8 h
diesel or coolants to flow into the ground. Please protect the en-
Every 8 h
vironment and dispose of liquids in an environmentally-friendly
Every 8 h
manner.
English

Preparing for maintenance work

Maintenance work
General safety instructions
DANGER
WARNING
CAUTION
WARNING
WARNING
CAUTION
DANGER
CAUTION
99