Danger Of Injury; Risk Of Injury - Kärcher MC 130 Classic Bedienungsanleitung

Radiator cap cover
1
Radiator cap
2
2. Tilt up the radiator cap cover.
3. Turn the radiator cap one click and allow the pressure in the
radiator to release.
4. Unscrew the radiator cap when the radiator has depressur-
ised.
5. Slowly fill the radiator all the way to the top without air bubbles.
6. Screw the radiator cap on tight.
7. Refill the coolant expansion reservoir. See chapter .
8. Reattach the panel.
Installing/removing the battery
DANGER

Danger of injury

Observe the safety regulations on the handling of batteries.
Minus terminal
1
Plus terminal
2
Support
3
1. Fit the battery into the battery holder.
2. Screw the bracket on the battery base tight.
3. Connect the terminal clamp (red cable) to the plus terminal (+).
4. Connect the terminal clamp (black cable) to the minus terminal
(-).
5. Plug the cover caps onto the terminal clamps.
CAUTION
Always disconnect the minus terminal first when removing the
battery.
Check that the battery terminals and terminal clamps are protect-
ed with a sufficient quantity of terminal grease.
102
DANGER

Risk of injury!

Only charge the battery with the appropriate charger.
Observe the safety instructions on the handling of batteries.
Follow the operating instructions of the charger manufacturer.
1. Disconnect the minus terminal at the battery.
2. Connect the charger to the battery.
3. Insert the mains plug and switch on the charger.
4. Charge the battery with as small a charging current as possi-
ble.
5. After charging, first disconnect the charger from the mains and
then from the battery (minus pole first).
6. Reconnect the battery.
Cleaning/replacing air filters
Lock
1
Air filter housing
2
Wing screw
3
1. Remove the right-hand side motor cladding.
2. Unscrew the wing screw approx. 2 turns
3. Pivot the complete air filter unit outwards as far as it will go.
4. Screw the wing screw tight.
5. Open the locks (2x) on the air filter housing.
6. Remove the air filter housing.
Air filter housing
1
Filter cartridge
2
Safety cartridge
3
7. Pull out the filter cartridge and safety cartridge.
8. Clean the entire interior of the air filter housing.
9. Knock the dust out of the filter cartridge on a hard surface.
Do not blow out the filter cartridge with compressed air.
10.Replace the safety cartridge with a new one.
Do not re-use a used safety cartridge.
11.Check that the filter cartridge and sealing surfaces are clean
and undamaged.
English
Charging the battery