Cleaning The Blower; Cleaning The Waste Container; Cleaning The Vehicle; Front Power Lift - Kärcher MC 250 Betriebsanleitung

2.5.4 Cleaning the blower

The fan cleaning attachment kit (2.852-587.0) can be used
for cleaning, if installed.
Fan cleaning connection
1
(1)Remove the blind cover of the C-coupling at the fan
cleaning connection.
(2)Connect a water hose and connect it to the domestic
water supply. An adapter from GEKA to C-coupling is re-
quired for this (not included in the scope of delivery).
(3)Preselect a motor speed of 1400 rpm.
(4)Switch on the PTO and blower (ideally with the waste
container closed).
(5)Open the water inlet.
(6)Operate the blower and until the desired result (approx.
3-5 minutes) is achieved.
(7)Reattach the blind cover.

2.5.5 Cleaning the waste container

Clean the suction mouth and the suction system first be-
fore cleaning the waste container. See chapter "Cleaning
the suction mouth and suction system".
Interior of waste container
1
Side channels
2
Rod engaged
3
Blower flap
4
Retaining clip
5
Exhaust grille
6
1. Park the vehicle.
2. Raise the waste container into the emptying position.
3. Rinse the inside of the sweep container and the side
channels with water.
4. If necessary, rinse the exhaust grille with water by pull-
ing out the retaining clips on the left and right and pivot-
ing the blow-out grille down.
44
5. Rinse the outside of the blower flap with water, first open
the blower flap with the rod (the rod engages).

2.5.6 Cleaning the vehicle

The vehicle with the waste container can be cleaned with
a high-pressure cleaner.
● Clean critical areas such as bearings, tyres, etc. with re-
duced pressure and without a rotary nozzle.
● Do not clean areas with electrical components with the
high-pressure cleaner.
Figure: Cleaning the vehicle
2.6

Front power lift

● Front power lift 2.852-755.0

2.6.1 Intended use

This chapter describes the attachment and removal of a
front power lift on an MC 250.
Various different attachments can be attached to the front
power lift using a 3-point mounting.
The attachment kit may only be used as intended.

2.6.2 Installing the front power lift

Changing carriage 2.852-067.0
1
Front power lift
2
Front power lift mounting
3
Hydraulic hose couplings (2x)
4
1. We recommend using a changing carriage 2.852-067.0
when attaching to the vehicle.
2. When attaching the front power lift for the first time (ap-
prox. 110 kg), use a crane or similar to position it on the
changing carriage.
3. Stop the vehicle on level, solid ground and secure it
against rolling away.
4. Open the lock, see chapter "Opening/closing the lock".
English