Stryker 6300 Bedienungsanleitung Seite 34

C C l l e e a a n n i i n n g g
C C l l e e a a n n i i n n g g t t h h e e p p r r o o d d u u c c t t
These instructions provide recommended cleaning methods for the Stryker Model 6300 S S T T 1 1 and S S T T 1 1 - - X X Series stretcher.
This product is power washable. The product may show some signs of oxidation or discoloration from continuous washing.
However, no degradation of the product's performance characteristics or functionality will occur due to power washing as
long as the proper procedures are followed.
Recommended cleaning method
1. Remove the mattress from the product.
2. Follow the cleaning solution manufacturer's dilution recommendations.
3. Hand wash all surfaces of the product with warm water and mild detergent.
4. Avoid over-saturation and make sure that the product does not stay wet longer than the cleaning solution
manufacturer's guidelines for proper cleaning.
5. Do not place the mattress on the product until the product is dry.
6. Check functionality before you return the product to service.
• Raise and lower the product
• Lock and unlock the brake/steer pedal in both positions
• Latch and unlatch the siderails
• Raise and lower the Fowler backrest
• Make sure that all components have proper lubrication
• Make sure that jack does not stick due to dust or debris
• Make sure that all labels are intact
N N o o t t e e
• Direct skin contact with visibly soiled, permeable material may increase the risk of infection.
• Do not steam clean the product.
• Clean the base hood storage area.
• Clean the bottom of the brake pads to prevent wax or floor remnant buildup.
• Some cleaning agents are corrosive in nature and may cause damage to the product. If you do not rinse and dry the
product well, a corrosive residue may be left on the surface of the product that could cause premature corrosion of
critical components. Failure to follow these cleaning instructions may void your warranty.
R R e e m m o o v v e e i i o o d d i i n n e e
1. Make a solution of 1 to 2 tablespoons of sodium thiosulfate in a pint of warm water. Use the solution to wipe down the
stained area.
2. Clean the stain as soon as possible after the stain occurs.
3. If stains are not immediately removed, allow solution to soak or stand on the mattress before you wipe the mattress.
4. Rinse the mattresses which have been exposed to the solution with clear water before you return the mattresses to
service.
N N o o t t e e - - Failure to follow these directions when you use these types of cleaners may void this product's warranty.
EN 30 KK-6300 Rev 04