Stryker 6300 Bedienungsanleitung Seite 19

R R a a i i s s i i n n g g t t h h e e l l i i t t t t e e r r
W W A A R R N N I I N N G G
• Always position the patient in the center of the product.
• Always put the product in the lowest position with the siderails up and latched when you leave a patient unattended. Do
not leave the product at a higher height.
• Always remove any devices that may be in the way before you raise or lower the litter.
• Do not sit on the end of the product. The product may tip.
C C A A U U T T I I O O N N - - Do not use the hydraulics on the base to raise the product with a patient lift under the product.
To raise the litter, press down on the pump pedal (A) until you achieve the desired height ( Base controls (page 14)).
L L o o w w e e r r i i n n g g t t h h e e l l i i t t t t e e r r
W W A A R R N N I I N N G G
• Always position the patient in the center of the product.
• Always put the product in the lowest position with the siderails up and latched when you leave a patient unattended. Do
not leave the product at a higher height.
• Always remove any devices that may be in the way before you raise or lower the litter.
• Do not sit on the end of the product. The product may tip.
C C A A U U T T I I O O N N - - Do not use the hydraulics on the base to raise the product with a patient lift under the product.
To lower the entire litter, press down on the center of the uni-lower pedal (B) ( Base controls (page 14)).
To lower the head end of the litter, press down on side of the uni-lower pedal (B) closest to the head end of the product.
To lower the foot end of the litter, press down on the side of the uni-lower pedal (B) closest to the foot end of the product.
P P o o s s i i t t i i o o n n i i n n g g t t h h e e p p r r o o d d u u c c t t i i n n T T r r e e n n d d e e l l e e n n b b u u r r g g
W W A A R R N N I I N N G G - - Always remove any devices that may be in the way before you raise or lower the litter.
C C A A U U T T I I O O N N - - Do not use the hydraulics on the base to raise the product with a patient lift under the product.
To position the product in the Trendelenburg position (head down), raise the litter to the highest height ( Raising the litter
(page 15)).
N N o o t t e e - - Raise the litter to the highest height for a greater Trendelenburg angle.
To lower the head end of the product, push down on the side of the uni-lower pedal (B) closest to the head end ( Base
controls (page 14)).
To lower the product from Trendelenburg position, push down on the center of the uni-lower pedal (B) until the litter is flat.
P P o o s s i i t t i i o o n n i i n n g g t t h h e e p p r r o o d d u u c c t t i i n n R R e e v v e e r r s s e e T T r r e e n n d d e e l l e e n n b b u u r r g g
W W A A R R N N I I N N G G - - Always remove any devices that may be in the way before you raise or lower the litter.
C C A A U U T T I I O O N N - - Do not use the hydraulics on the base to raise the product with a patient lift under the product.
To position the product in the Reverse Trendelenburg position (foot down), raise the litter to the highest height ( Raising the
litter (page 15)).
KK-6300 Rev 04 15 EN