Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S S e e t t u u p p
To unpack your product, see the unpacking instructions that are attached to the product inside of the shipping crate.
W W A A R R N N I I N N G G
• Always allow the product to reach room temperature before you set up the product or test functional operations.
Permanent product damage may occur.
• Always operate the product only when all operators are clear of the mechanisms.
• Always use mattress (6300-0-100, 6300-0-102, 6300-0-103, or 6300-0-104) on the Stryker Model 6300 S S T T 1 1 and S S T T 1 1 - - X X
Series stretcher. Use of any other mattress may result in patient injury.
• Always use caution when you use a mattress thicker than 6.35 cm (2.5 inches) with S S T T 1 1 - - X X option. Operator supervision
is recommended to reduce the risk of patient falls due to lesser siderail coverage.
C C A A U U T T I I O O N N - - Always transport the S S T T 1 1 and S S T T 1 1 - - X X Series stretcher on floors made of wood, concrete, or ceramic tile. If
floors are covered with synthetic material, the relative humidity should be at least 30% to avoid electrostatic discharge.
Make sure that the product works before you put the product into service.
1. Apply the brake. Push on the product to make sure that all four casters are locked.
2. Release the brake. Push on the product to make sure that all four casters are unlocked.
3. Raise and lower the litter with the hydraulic lift system.
4. Raise the product to the highest position and put the product in the Trendelenburg position. Make sure that the head end
lowers to the full down position.
5. Raise the product to the highest position and put the product in the Reverse Trendelenburg position. Make sure that the
foot end lowers to the full down position.
6. Apply the fifth wheel and make sure that the fifth wheel guides and pivots the product.
7. Make sure that the siderails raise, lower, and lock in place.
8. Raise and lower the manual Fowler backrest (head section).
S S e e t t u u p p t t h h e e m m a a t t t t r r e e s s s s
W W A A R R N N I I N N G G
• Always use linens with the mattress.
• Do not stick needles into the mattress cover. Holes may allow body fluids to enter the inside (inner core) of the mattress
and may cause cross-contamination or product damage.
• Always use the mattress with a compatible frame as indicated in the specification section of this manual.
To setup the mattress:
1. Place the mattress on a compatible stretcher.
2. Make sure that you align the mattress with the Stryker logo at the head end of the stretcher.
3. Align the hook and loop fastener onto the bottom cover of the mattress to the litter deck of the stretcher.
4. Make sure that the water shed flaps cover the zipper.
5. Place linens on the mattress before patient use. Follow your hospital protocols.
EN
12
KK-6300 Rev 04
Werbung
