Alarm And Fault Indications - Bosch ADW 511A Installationsanleitung

54 en | Alarm and fault indications
9

Alarm and fault indications

The ADW 511A is equipped with three LEDs for displaying alarms and faults. Depending on the
type of event, these LEDs will light up or flash individually, in combination or in different flash-
ing sequences. The POWER/FAULT LED is two-colored: green indicates the operating state
and yellow indicates a fault.
System off (no voltage)
System inactive
Standby
Differential pre-alarm
Maximum pre-alarm
Differential alarm
Maximum alarm
Alarm temperature sensor
General fault
Leakage fault
Pinching fault
Wrong initial setup
Manual test
Hard reset
1.
2.
3.
4.
The alarm and fault types described in the following and the relays and LEDs activated in the
process are factory-programmed and cannot be changed.
BDL -F.01U.004.036 | A2 | 2006.11
Status/LED
1
1
2
3
4
If configured via software
An activated LED that does not flash indicates that an additional alarm or fault has been
triggered
As long as the test is running (program selection switch on D)
As long as the test motor is running (program selection switch on 0)
Installation Guide
ALARM DIFF/ ALARM MAX/
red red
off off
flashes 3:1 flashes 3:1
off off
flashes 1:1 off
off flashes 1:1
on off
off on
on on
off off
off off
off off
flashes 3:1 flashes 3:1
flashes 1:1 flashes 1:1
on on
Linear heat detector ADW 511A Transafe
POWER/ FAULT/
green yellow
off
flashes 1:3 flashes 3:1
on
on
on
on
on
on
off
flashes 1:1 flashes 1:1
flashes 1:3 flashes 3:1
flashes 1:3 flashes 3:1
flashes 1:1 flashes 1:1
off
Bosch Sicherheitssysteme GmbH
off
off
off
off
off
off
off
on
on