Main Display; Control Menu (Control) - Cameo OPUS S5 CLOS5 Bedienungsanleitung

MAIN DISPLAY

The upper line of the display shows whether and which control signal is present on the device, the line below shows the currently active
control mode (DMX Standard / Extended, Static, Auto, Slave), and well visible in the middle is the DMX start address or the corresponding
operating mode (e.g. DMX start address 001). As soon as the control signal is interrupted, the characters on the display will begin to flash
and "None" will display behind "Signal" on the upper line (no signal). When the control signal is again present, the screen will switch back
to the main display. The display can be rotated by 180° by pressing the touch-sensitive DOWN control key. If the display is already rotated
180°, press the UP control key to return the display to its standard position. The display can also be rotated 180° by pressing the "roof"
symbol on the pressure-sensitive display.
Input signal display
DMX mode or operating mode
DMX start address or
operating mode
Information on device model
Back to main display = press any-
where on display or ENTER

CONTROL MENU (Control)

SETTING THE DMX START ADDRESS (DMX Address)
Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the Control menu and
press ENTER. Using the UP and DOWN buttons, now select the "DMX Address" menu option and confirm via ENTER. Set the desired DMX
start address using the LEFT and RIGHT buttons, and confirm via ENTER (highest value depends on active DMX mode). Press MODE 2x to
return to the main display, the selected DMX start address will now be displayed enlarged when the DMX mode is active.
SETTING THE DMX MODE (DMX Mode)
Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the Control menu and
press ENTER. Using the UP and DOWN buttons, now select the "DMX Mode" menu option and confirm via ENTER. Select the desired DMX
mode via UP and DOWN and confirm by selecting ENTER. Press MODE 2x to return to the main display, the selected DMX mode is now
active. You can find tables on channel assignment in the different DMX modes in these instructions under DMX CONTROL.
8
Display battery status
Rotate display by 180°
Main menu