Connections, Operating And Display Elements - Cameo OPUS SP5 PLUS Bedienungsanleitung

ADDITIONAL PROPERTIES
The CLOSP5P moving head comes equipped with a 4-way framing shutter module. The 4-way
framing shutter module can be interchanged with the CLOSP5AM animation wheel module. The
software and corresponding DMX modes are upgraded automatically.

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

8
3
1 POWER IN
Neutrik powerCON TRUE1 mains input socket. Operating voltage 100–240 V AC/50–60 Hz. A
suitable mains cable with powerCON TRUE1 plug is included.
2 POWER OUT
Neutrik powerCON TRUE1 mains output socket. Facilitates power supply to other CAMEO spot-
lights. Ensure that the total power consumption of all devices connected to the device does not
exceed the given ampere (A) value.
3 FUSE
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT NOTE: Replace the fuse only with one of the
same type and rating. In the event of repeated fuse failure, please contact an authorised service
centre.
4 DMX IN
Male 3-pin and 5-pin XLR sockets for connection of a DMX control device (e.g. DMX console).
5 DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal.
12
1 2
6
4
7
5