Getting To Know The Button Combination Functions - Argo MONOSPLIT R32 WIFI Bedienungs- Und Wartungsanleitung

5. In auto mode the internal fan operates in auto quiet mode according to the current modes: cooling, heating
and ventilation.
Wi-Fi button
Press this button to start the Wi-Fi function. When the Wi-Fi function is active, the "Wi-Fi" icon will appear on
the remote control display. When the remote control is off, press and hold the "Mode" button and the "Wi-Fi"
button simultaneously for 1 sec to return to the factory settings.
LIGHT button
Press this button to turn off the indoor unit's display light. The
display. Press this button again to turn on the display light. The
HEALTH/SCAVENGING button
The HEALTHY function means that cold plasma kills bacteria, removes odors and releases negative oxygen
ions.
The SCAVENGING or purification function it's not available.
TEMP button
Pressing this button will allow you to display the set temperature, the indoor ambient temperature, or the outdoor
ambient temperature on the indoor unit's display. You can cycle through the settings on the remote control
display as shown below:
When you select
•
unit's display.
When you select
•
unit's display.
When you select
•
unit's display.
N.B.:
• It is not possible to display the outdoor ambient temperature on all models. The indoor unit will receive the
signal but will display the set temperature.
• The set temperature will appear on the unit's display on start-up, if enabled to do so.
• When you select to display the indoor or outdoor ambient temperature, the indoor unit will display the
corresponding temperature for three to five seconds, after which it will automatically revert to displaying
the set temperature.

Getting to know the button combination functions

X-FAN function
By holding down the FAN button for 2 seconds in Cool (cooling) or DRY (dehumidification) mode, the icon
will appear and the internal fan will continue to operate for a few minutes in low ventilation speed, even when
the unit is turned off. This is to allow the evaporator of the indoor unit to dry, thus avoiding the formation of mold.
When the unit is switched on, the X-fan function is not set by default.
This function is not available in AUTO, fan and heat modes.
If you want to stop the X-fan function, press and hold the FAN button again for 2 seconds.
or "no display" with the remote control, the set temperature will appear on the indoor
with the remote control, the indoor ambient temperature will appear on the indoor
with the remote control, the outdoor ambient temperature will appear on the indoor
76
icon will disappear from the remote control
icon will appear on the display.