On/Off Button; Mode Button - Argo MONOSPLIT R32 WIFI Bedienungs- Und Wartungsanleitung

ON/OFF button

Press the ON/OFF button to turn the air conditioner on or off. When you turn on the air conditioner, the power
indicator on the indoor unit's display will illuminate (green). The colour varies for different models. The indoor
unit will emit a beep.

MODE button

Press this button to select the desired operating mode.
 When you select automatic mode, the air conditioner will operate automatically according to the factory settings.
The set temperature cannot be adjusted and will not be displayed. Pressing the "FAN" button will allow you to
adjust the fan speed. Pressing the "SWING" button will allow you to adjust the angle of airflow.
 When you select cool mode, the air conditioner will run in cool mode. The  indicator will illuminate on the
display. Press "▲" or "▼" to adjust the set temperature. Press the "FAN" button to adjust the fan speed. Pressing
the "SWING" button will allow you to adjust the angle of airflow.
 When you select dry mode, the air conditioner will run at low speed in dry mode. The
on the display. The fan speed cannot be adjusted in this mode. Pressing the "SWING" button will allow you to
adjust the angle of airflow.
 When you select fan mode, the air conditioner will operate only the fan, blowing air without cooling or heating.
All the indicators will switch off. Press the "FAN" button to adjust the fan speed. Pressing the "SWING" button
will allow you to adjust the angle of airflow.
 When you select heat mode, the air conditioner will run in heat mode. The
display. Press "▲" or "▼" to adjust the set temperature. Press the "FAN" button to adjust the fan speed. Pressing
the "SWING" button will allow you to adjust the angle of airflow.
N.B.:
To prevent blasts of cold air from being blown into the room, there will be a delay of 1 – 5 minutes after selecting
heat mode before operation begins. (The actual delay will depend on the indoor ambient temperature).
The temperature can be set between 16 – 30°C and four fan speeds are available: automatic, low, medium and
high.
FAN button
Pressing this button will allow you to cycle through and set the fan speed: automatic (AUTO), Low ( ), Low-
medium( ) Medium (
N.B.:
The fan speed in dehumidification mode is low.
Pressing the ventilation speed button for 2 seconds in Cooling or Dehumidification mode activates the X-FAN
function and the icon appears on the remote control: the unit will continue to ventilate for a few minutes, even
after switching off the unit, to dry the battery of the indoor unit, thus preventing the formation of mold. This
function is not available in Auto, Ventilation or Heating mode.
If the X-FAN function has been selected: after turning off the unit with the ON / OFF button, the indoor unit fan
will continue to run for a few minutes at low speed. During this time, press the FAN key for 2 seconds to stop
the fan.
(
), Medium-high
72
indicator will illuminate on the
), High ( ).
indicator will illuminate