Uncoupling From The Movita Ceiling Supply Unit - Dräger Atlan A3-Serie Bedienungsanleitung

4. Tighten the four M6x35 hexagon socket screws (1).
Tightening torque: 10 Nm
5.3.2.2 Ceiling-mounted version with integrated castors
1. Connect Atlan to the ceiling supply unit.
2. Unscrew the four M6x35 hexagon socket screws (1) on the clamping bar.
3. Move the clamping bar at a distance of 16 mm from the upper edge of the device
mount.
4. Tighten the four M6x35 hexagon socket screws (1).
Tightening torque: 10 Nm
5.4

Uncoupling from the Movita ceiling supply unit

The following describes how to undo the clamping rail for the Movita ceiling supply
unit. The exact procedure for disconnecting the Atlan ceiling-mounted versions
from the ceiling supply unit is described in the supplement "Atlan A300, A350
ceiling-mounted versions and wall-mounted version".
Check that the floor under the device is level and cleared. There must be no
objects under the device.
|
Kit
Atlan A3xx SW 2.0n ceiling-mounted versions
Connecting Atlan to the Movita ceiling supply unit
|
41