Inhaltsverzeichnis
Werbung
2. Tighten the four M6x35 hexagon socket screws (2) by hand. Then loosen it
again with 1/2 turn.
5.3
Coupling to the Movita ceiling supply unit
The following describes the exact alignment of the clamping rail for the Movita
ceiling supply unit. The exact procedure for coupling the Atlan ceiling-mounted
version to the ceiling supply unit is described in the supplement "Atlan A300, A350
ceiling-mounted versions and wall-mounted version".
5.3.1
Preparing Atlan for coupling to a ceiling supply unit
5.3.1.1
Removing the cable ducts
1. Remove the eight M4x10 screws (1). Remove the cable ducts (2).
|
Kit
Atlan A3xx SW 2.0n ceiling-mounted versions
Connecting Atlan to the Movita ceiling supply unit
|
39
Werbung
Inhaltsverzeichnis
