Preparation For Operation; Switching On The Instrument - Dräger X-am 5600 Gebrauchsanweisung

Name
Alarm threshold TWA
(in measuring unit)
1) Interpretation only if the sensor is designed for this.
5.3 Check of parameters
To ensure that the values were correctly transferred to the gas detection
instrument:
1. Press the data from X-am 1/2/5x00 in Dräger CC Vision.
2. Check parameters.
6 Operation
6.1

Preparation for operation

Before using the instrument for the first time, insert a charged NiMH T4

power pack or batteries approved by Dräger, see Chapter "Replacing the
batteries / rechargeable batteries" on Page 41.
The instrument is ready for operation

!
WARNING
To reduce the risk of ignition of a flammable or explosive atmosphere, strictly
adhere to the following warning statements:
Only use power pack types ABT 01xx, HBT 00xx or HBT 01xx. See the marking
on the rechargeable battery for permitted rechargeable batteries and the
corresponding temperature class.
Substitution of components may impair intrinsic safety.
6.2

Switching on the instrument

1. Hold down the [OK] key for approx. 3 seconds until the countdown
» 3 . 2 . 1 « shown on the display has elapsed.
All the display segments, including the visual, audible and vibration

alarms, are activated for a short time.
The software version is displayed.

The instrument performs a self-test.

The sensor that is up next for adjustment is displayed with the

remaining days until the next adjustment, e.g. » ch
1)
Range
Capture range – full scale value
4
Operation en
LEL CAL 123 «.
35