Environmental Conditions; Qualified Personnel; Noise Emission Values; Emc Measures - Fronius Ohmpilot Bedienungsanleitung

Any safety devices that are not fully functional must be repaired by an authori-
sed specialist before the device is switched on.
Never bypass or disable protection devices.
For the location of the safety and danger notices on the device, refer to the sec-
tion headed "General remarks" in the Operating Instructions for the device.
Any equipment malfunctions which might impair safety must be remedied before
the device is turned on.
This is for your personal safety!
Environmental Operation or storage of the device outside the stipulated area will be deemed as
conditions not in accordance with the intended purpose. The manufacturer accepts no liabi-
lity for any damage resulting from improper use.
Qualified per- The servicing information contained in these operating instructions is intended
sonnel only for the use of qualified service engineers. An electric shock can be fatal. Do
not carry out any actions other than those described in the documentation. This
also applies to qualified personnel.
All cables and leads must be secured, undamaged, insulated and adequately di-
mensioned. Loose connections, scorched, damaged or inadequately dimensioned
cables and leads must be immediately repaired by authorised personnel.
Maintenance and repair work must only be carried out by an authorised specia-
list.
It is impossible to guarantee that bought-in parts are designed and manufactu-
red to meet the demands made on them, or that they satisfy safety require-
ments. Use only original spare parts (also applies to standard parts).
Do not carry out any alterations, installations, or modifications to the device wi-
thout first obtaining the manufacturer's permission.
Components that are not in perfect condition must be changed immediately.
Noise emission
The maximum sound power level of the inverter is specified in the Technical Da-
values ta.
The device is cooled as quietly as possible with the aid of an electronic tempera-
ture control system; this depends on the amount of converted power, the ambi-
ent temperature, the level of soiling of the device, etc.
It is not possible to provide a workplace-related emission value for this device
because the actual sound pressure level is heavily influenced by the installation
situation, the power quality, the surrounding walls and the properties of the room
in general.

EMC measures

In certain cases, even though a device complies with the standard limit values for
emissions, it may affect the application area for which it was designed (e.g. when
there is sensitive equipment at the same location, or if the site where the device
is installed is close to either radio or television receivers). If this is the case, then
the operator is obliged to take appropriate action to rectify the situation.
72