Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.6
First commissioning
CAUTION!
First commissioning may only take place after proper installation.
WARNING!
The use of improper tool holders or their operation at inadmissible speeds constitutes a
hazard.
Only use the tool holders (e.g. drill chuck) which were delivered with the machine or
which are offered as optional equipment by OPTIMUM.
Only use tool holders in the intended admissible speed range.
Tool holders may only be modified in compliance with the recommendation of OPTIMUM or of
the manufacturer of the clamping devices.
WARNING!
There is a danger to persons and equipment, if the first commissioning of the drilling
machine is carried out by inexperienced personnel.
We do not accept any liability for damages caused by incorrectly performed
commissioning.
„Qualification" auf Seite 67
3.7
Electrical connection
WARNING!
400V three-phase connection
The three-phase electrical connection may only be performed by an electrician or under
the guidance and supervision of an electrician.
CAUTION!
Arrange the machine's connection cable in such a way that it will not cause a tripping
hazard.
ATTENTION!
Ensure that all 3 phases (L1, L2, L3) and the ground wire are connected correctly.
The neutral conductor (N) of its power supply is not connected.
ATTENTION!
Observe the rotating field!
Please check that the type of current, voltage and protection fuse correspond to the values
specified. A protective earth ground wire connection must be available.
Mains fuse 10A to 16A
INFORMATION
Machines with 400V three-phase connection.
Use the rotational direction switch to set the correct direction of rotation. In the switching posi-
tion "R", the spindle should turn clockwise. If necessary, swap two phases on the power plug to
obtain the correct direction of rotation.
EN
D17 Pro│D23 Pro│D26 Pro│D33 Pro
88
Translation of original instruction
Version 1.0.3 - 2022-04-06
Werbung
Inhaltsverzeichnis
