Optimum OPTIdrill D 17Pro Betriebsanleitung Seite 106

Interval Where?
in case of need
INFORMATION
The spindle bearing is lifetime-lubricated. It is not necessary to lubricate it again.
EN
D17 Pro│D23 Pro│D26 Pro│D33 Pro
106
What? How?
Any unusual rattling noises can be eliminated by regreasing. The
sleeve (1) moves downwards or upwards with the toothed spindle
(2) in the fixed driven sleeve (3) during drill feed. The noises are
caused by the necessary clearance between the two toothings of
the sleeve and spindle. The grease in the delivery condition may
have been used up.
2
1
Img. 6-3:
Regreasing is carried out from above via the spindle drive. Apply
grease at the visible toothed area of the spindle. It is
recommended to use a grease which can remain permanently
inside the toothing. The grease "Staburag NBU 30 PTM" from
Klüber is recommended and has proved to be a successful
assembly grease for clearance fits.
Translation of original instruction
3
2
3

Obligations of the User on page 67

Electronics on page 72
Maintenance
Version 1.0.3 - 2022-04-06