Use; Switching The Device On And Off - mectron Piezosurgery flex Gebrauchs- Und Wartungsanleitung

5

USE

5.1 Switching the Device On and Off
Switching the Device On
Facing the front of the device, press the
power switch on the left of the device
body to the "I" position, being careful not
to press the foot pedal. The device does
a self-test and 4 symbols appear on the
device (ref. P inside cover). At the end of
the self-test the symbols turn off one by
one, the device sets on the default setting
and is ready to be used.
Switching the Device Off
Facing the front of the device, press the
power switch on the left of the device
body to the "o" position, being careful
not to press the foot pedal. The device
turns off.
NOTE: whenever the device is started,
the following default setting is
programmed:
• "Power" 1;
• "irrigation" 1;
• "mode" 1.
CAUTION: Once turned off, It is
necessary to wait 5 seconds before
switching the device on again. The
device can give an error message.
16
flex
on
off