Transport, Installation, And Storage - Abicor Binzel ABIBUG 300 Originalbetriebsanleitung

ABIBUG 300

5 Transport, installation, and storage

Risk of injury due to improper transport and installation
Improper transport and installation can cause the device to tip or fall over. This may result in serious
injuries.
► Check and wear your personal protective equipment.
► Note the weight of the device when lifting it.
► Use an appropriate lifting tool with load handling attachment for transporting and installing
► Transport the device only by the handle.
► Transport the device only over even ground.
► Watch out for obstacles.
► Avoid abrupt lifting and setting down.
► Do not lift the device over persons or other devices.
► Place the device on a suitable base (flat, solid, dry) on which it will not topple over.
► Send bystanders out of the danger zone.
NOTICE
Risk of material damage due to improper transport, installation, and storage
Improper transport, installation, or packaging can result in damage to the device. This can result in
material damage and irreparable damage to the device.
► Protect the device against weather conditions, such as rain and direct sunlight.
► Use the device only in dry, clean and well-ventilated rooms.
► Pack the device before transportation/storage per Fig. 8.
Physical storage conditions in a closed environment:
 Tab. 3 Ambient conditions for transport, storage and operation on page EN-18
The device is delivered in a trolley and separated into two levels as follows:
Fig. 8
The trolley is equipped with a pressure-relief screw. This automatically equalizes the low pressure inside
the trolley caused by air transport.
6 Commissioning
You will require the below tools for the following activities:
— AF8/10/19 fork wrench
— Fork wrench with AF8 T-handle
— Phillips screwdriver PH1
— AF2.5/3/8 Allen key
— Cutter
— Cotter pin drive size 2
— Folding ruler
WARNING
 4.4 Technical data on page EN-17
 Fig. 8 Trolley on page EN-20
the device.
Trolley
5 Transport, installation, and storage
EN - 19