Putting Into Operation; Transport And Installation En - Abicor Binzel iROB Feed 22/MP Betriebsanleitung

iROB Feed

6 Putting into operation

Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system..
Risk of crushing
Limbs can be drawn in and crushed.
• Do not reach into moving wheels.
NOTICE
• Please take note of the following instructions:
• The system may only be installed and put into operation by authorized personnel
• Components must only be used in dry environments with sufficient ventilation.
6.1 Transport and installation
Risk of injury
Physical damage due to falling devices and mounting parts.
• Avoid abrupt lifting and setting down.
• Do not lift the components over persons or other devices.
• Transport the components in upright position.
• Please observe the weight of the individual components.
Risk of toppling
Physical damage or damage to components due to improper mounting.
• Separate the supply lines.
• Place the components on a suitable base (flat, tight, dry) that prevents them from tipping.
• Please observe the max. angle of inclination of 10°.
NOTICE
• Ensure free access to the operating components and connections.
• Select a location that allows a short and rectilinear wire feed.
• Protect the components against rain and direct solar radiation.
• Use the device only in dry, clean and well-ventilated rooms.
BAL.0331.0 • 2017-08-31
DANGER
WARNING
 3 Product description on page EN-6
(in Germany see TRBS 1203).
CAUTION
 3.1 Technical Data on page EN-6
CAUTION
6 Putting into operation
EN - 11