Transport And Installation En - Abicor Binzel ABIDRIVE 2 Betriebsanleitung

6 Putting into operation
6.1 Transport and installation
Risk of injury
Physical injury due to falling devices and add-on components.
• Avoid abrupt lifting and setting down.
• Do not lift the components over persons or other devices.
• Transport the device in an upright position with the plug disconnected and all connection cables
• Wear your personal protective equipment: safety shoes with steel toe caps, protective work gloves,
• Send bystanders out of the danger zone.
Risk of toppling
Physical injury or damage to components due to improper assembly.
• Disconnect the supply lines.
• Secure the ABIDRIVE to prevent it from toppling over or falling.
• Place the components on a suitable base (flat, solid, dry) on which they will not topple over.
• Note the max. tilt angle of 15°.
NOTICE
• Ensure clear access to the control elements and connections.
• Install the ABIDRIVE cold-wire feeder with a circumferential clearance of 50 cm to ensure optimum
• Prevent dust and other foreign substances from entering the system's cooling air stream.
• Protect the components against rain and direct sunlight.
• Only use the device in dry, clean and well-ventilated rooms.
EN - 10
CAUTION
removed.
safety helmet, ear protectors.
CAUTION
cooling air circulation.
TIG cold-wire feeder