Description Of Components - Sabo 43-VARIO E Betriebsanleitung

Protective gloves must be worn at all times during maintenance and
cleaning work.
Maintenance and cleaning work may only be carried out on level surfaces
with the engine switched off, spark plug connector disconnected and
ignition key removed.
Regular maintenance is essential for safety and top performance.
• Never remove the spark plug connector when the motor is running! Risk: Electric
shock.
• Disconnect the spark plug connector only when the engine has cooled down.
Danger of burns!
• Make sure that the spark plug connector is firmly seated! Risk: Electric shock.
• If the tank has to be emptied, this should be done in the open, and with a
cold engine. Take care to ensure that no fuel is spilt.
Always store the equipment in a clean state in a closed, dry room and
inaccessible to children.
Always remove the ignition key during storage to prevent unauthorised
actuation of the starter or mower.
For reasons of warranty and safety, only genuine spare parts may be used.
Non-equivalent spare parts can damage the machine and are a safety hazard.

7 DESCRIPTION OF COMPONENTS

47-VARIO E
1 Safety control bar for motor stop
2 Knob for Vario actuation
3 Drive control bar
4 Oil refill neck with dipstick
5 Battery compartment with battery
6 Engine cover
7 Cutting height adjustment
8 Spark plug
9 Exhaust protection grid
10 Carrying handle
11 Belt drive covers
12 Air filter
13 Tank cap
14 Ejector flap
15 Starter key
43-VARIO E
1 Safety control bar for motor stop
2 Vario actuation
3 Drive control bar
4 Tank cap
5 Engine cover
6 Cutting height adjustment
7 Air filter
8 Spark plug
9 Carrying handle
10 Exhaust protection grid
11 Belt drive covers
12 Oil refill neck with dipstick
13 Battery compartment with battery
14 Ejector flap
15 Fast release (depending on the model)
16 Starter key
All models
8 PREPARATION
The following unit parts are included in the package for mower assembly:
• Mower with pre-assembled guide bar
• Grass catch, collecting bag frame
• Tool bag containing the following:
– Operator's manual with Declaration of Conformity
– Warranty conditions
– Diverse attachment parts.
Should a part be missing, please contact your professional dealership.
NOTE
Always remove the spark plug connector before fitting the bar. Following
assembly, at the latest before starting the engine, push the spark plug connector
back in place.
Raise the handlebar (Illustration A1 + B1 + V4 + E1 )
IMPORTANT
Make sure the throttle cables are not kinked or jammed when lifting the
handlebars.
IMPORTANT
Make sure that the cables are not pinched, squeezed, twisted or overstretched
when the handlebars are folded apart or collapsed! Always run the cables along
the outside of the bar connection. A damaged cable may result in a technical
defect of the equipment.
Pull the handlebar which is collapsed in a Z-shape upwards into place in the following
sequence:
– First lift the bottom part of the handlebar A1 , push the ends of this bottom part as
far apart as necessary for the locking cams facing the inside to lock into the
respective bore holes B1 .
Three different handlebar heights can be set.
– Tighten the wing nuts on both sides by hand B1 .
6