Inhaltsverzeichnis
Werbung
SIDE CONTROL BRAKE ROD REMOVAL
Tools Required:
• Hammer
• 7/32" Roll Pin Punch
• Needle Nose Pliers
• Bungee Cords
• 3/8" Drive Torque Wrench (ft-lb)
•
Procedure:
1 .
Pump the litter up to full height .
2 .
Lift the base hood and support it from the litter using bungee cords .
3 .
Remove the rue ring cotter and clevis pin connecting the rod end link to the side control link .
4 .
Remove the four bolts holding the brake rod assembly to the base frame and remove the entire assembly .
5 .
Using a hammer and 7/32" roll pin punch, drive the slotted spring pin out of the butterfly "V" pedal on the patient's
left side and remove the pedal .
6 .
Using a hammer and 7/32" roll pin punch, drive the slotted spring pin out of the hard stop in the center of the
support weldment .
7 .
Using a hammer and 7/32" roll pin punch, drive out the slotted spring pin connecting the side control link to the
side control brake rod on the patient's right side .
8 .
Pull on the butterfly "V" pedal on the patient's right side to remove the side control brake rod from the base .
9 .
Reverse steps to reinstall the brake rod . When reinstalling the assembly, torque the hex head cap screws to 5-13
ft-lb .
10 . Verify proper operation of the unit before returning it to service .
CAUTION
When reattaching the brake rod assembly to the base frame, set the torque specifications no higher than 13 ft-lb or
damage could occur to the bolts .
www.stryker.com
Service Information
0747-009-006 REV J
Return To Table of Contents
1-23
English
Werbung
Inhaltsverzeichnis
