Searching For The Time And Date - Sony SVT-RA96P Bedienungsanleitung

Searching for the Time and Date — Time/Date Search

Searching for the Time and Date

1
1
Turn on the power of the equipment to be used.
2
Press SEARCH in stop mode until the time/date
search indicator flashes in the display window and
on the monitor screen.
When CONV. is selected for T/D SEARCH on
the GENERAL SET menu:
In the display window
When NEW is selected for T/D SEARCH on the
GENERAL SET menu:
In the display window
42
3 2 4
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1 1 2
Hour
Date
On the monitor
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1 1 2 2 0
Minute
Hour
Date
On the monitor
3
Press MENU + or – to set the date and press
MENU B to move the flashing to the time. Press
MENU + or – to set the time. Set the minute (when
NEW is selected) on the same way.
4
Press FF M or REW m.
The cassette stops at the portion when you set the
time and date and the still picture playback is
displayed.
The time/date search mode is automatically
cleared.
Notes
• If the tape reaches its end during searching, the tape is
rewound and the unit enters the stop mode at the beginning
of the tape.
• Be sure to set T/D SEARCH on the GENERAL SET menu
to the same setting as the tape was recorded with.
Otherwise, searching for the time and date cannot be done
properly.
• You can use the T/D SEARCH only when the alarm speed
is set to 8H (when using E-240 tape) or 6H (when using E-
180 tape) and the recorded section is longer than 20
seconds.