Rec Out Terminal; Remote Jack - Sony SVT-RA96P Bedienungsanleitung

4
Press MENU V to move the flashing to the setting
of MODE of the SW OUT SET menu and set to
FIELD or FRAME by pressing MENU + or – and
press MENU V again.
5
Set TIMING by pressing MENU + or – and press
MENU V.
6
When TAPE in the GENERAL SET menu is set
to E-240:
Set 8H MODE (8-hour mode) to ON or OFF by
pressing MENU + or –.
ON: a signal is output in the 8-hour mode.
OFF: a signal is not output in the 8-hour mode.
When TAPE in the GENERAL SET menu is set
to E-180:
Set 6H MODE (6-hour mode) to ON or OFF by
pressing MENU + or –.
ON: a signal is output in the 6-hour mode.
OFF: a signal is not output in the 6-hour mode.
7
Press SEARCH to return to the normal display.

REC OUT Terminal

While recording or recording pause, the VCR outputs a
pulse signal from REC OUT terminal.
Tape recording starts.
Recording is in
5 V
progress.
0 V
The VCR can be remotely controlled by adding the
circuit shown below to the REMOTE jack or by using
the SVT-RM10 Remote Control Unit (not supplied).
• Use a shielded cord less than 5 m (16 ft.) in length.
• The recording indicator on the SVT-RM10 lights up when
The VCR enters
recording pause
mode.

REMOTE Jack

SW1 ......... STOP
SW2 ......... PAUSE
SW3 ......... REW
SW4 ......... FF
SW5 ......... PLAY
SW6 ......... REC
SW7 ......... MENU
SW8 ......... REV
SW9 ......... REC/PLAY SPEED+
SW10 ....... REC/PLAY SPEED–
SW11 ....... MENU V
SW12 ....... MENU B
Resistor tolerance should be
equal to or less than ±2%.
Notes
using with this VCR.
REMOTE jack
R2 1.5K
SW1
R3 0.43K
SW2
SW3 R4 0.51K
R5 0.62K
SW4
R6 0.75K
SW5
R7 0.91K
SW6
R8 1.1K
SW7
R9 1.3K
SW8
R10 2.0K
SW9
R11 2.4K
SW10
R12 3.6K
SW11
R13 5.6K
SW12
47