Setting The Alarm Recording Mode - Sony SVT-RA96P Bedienungsanleitung

Alarm Recording
5
Press MENU V to move the flashing to the setting
of ALARM DURATION and set 20S, 40S, 1MIN,
2MIN, 3MIN, 4MIN, 5MIN or CC by pressing
MENU + or –.
20S - 5MIN: for recording for 20 seconds, 40
seconds, 1 minute, 2 minutes, 3 minutes, 4
minutes or 5 minutes
CC: for recording as long as the alarm signal is
being input
6
Press SEARCH to return to the normal display.
To return to the MAIN MENU screen from the
current menu
Press MENU again.
To go to the next menu from the current menu
Press MENU V while keeping MENU B pressed.
Setting the Alarm Recording
Mode
1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "4" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The ALARM SET menu appears.
34
4
Set ALARM MODE to A1, A2, A3 or OFF by
pressing MENU + or –.
A (alarm)1: always accepts alarms.
A2: accepts alarms only when timer recording is
proceeding.
A3: accepts alarms only when timer recording is
standby.
OFF: does not accept alarm even if an alarm
signal is received.
5
Press SEARCH to return to the normal display.
To return to the MAIN MENU screen from the
current menu
Press MENU again.
To go to the next menu from the current menu
Press MENU V while keeping MENU B pressed.
Notes
• While alarm recording is in progress, other modes are
inoperable.
• After the alarm recording is completed, the VCR returns to
the condition it was in before the alarm signal was
received.
• If an alarm input is received while the VCR is in repeat
recording mode (see page 22), repeat recording stops and
the REPEAT indicator goes out. After the tape reaches the
end, the tape is rewound and the VCR stops. The OFF
indicator lights in the display window (only when
REPEAT 1 is selected for TAPE END MODE in the
GENERAL SET menu).
• When the OFF indicator lights, in order to prevent
accidental erasure of a recorded tape, timer recording and
alarm recording cannot be executed. However, if the VCR
is in series recording mode (see page 22), timer recording
and alarm recording will be executed even when OFF
indicator lights.
If any of REC z, FF M, REW m, PLAY B, STOP x
is pressed, the OFF indicator goes out.
• If another alarm is received while alarm recording is in
progress, the second alarm recording starts and the
recording duration is extended.
• If the power is interrupted while alarm recording is in
progress and restored again, the operation before the alarm
recording was made resumes.
• To stop alarm recording, short-circuit between the
ALARM RESET IN and COM terminals.