First Use; Before First Use - Gastroback Design Espresso Slim Bedienungsanleitung

wand tip is completely clear. An even partly blocked steam wand may affect
the ability of the steam wand to produce a satisfactory amount of froth.
• Prior to texturing milk, we recommend to purge the steam wand by shortly ope-
rating the steam function to make the steam flow for 1-2 seconds.
• Always start with fresh, cold milk. Fat-reduced milk will give the best results.
However, different brands and types of milk and milk alternatives will texture dif-
ferently. Additionally, the freshness of the milk will have high influence. You may
need to adjust the procedure accordingly. You may use the steam function with
or without stainless steel sleeve. Just give it a try. To remove the stainless steel
sleeve, hold the steam wand by the handle and turn the stainless steel sleeve
to and fro while pulling it downwards. To re-assemble the stainless steel sleeve,
simply push the stainless steel sleeve back onto the steam wand until there is no
gap left between the stainless steel sleeve and the steam wand handle.
• You should consume textured milk immediately as the froth will collapse after a
while.
• When not in use, the steam wand may be left immersed in a high vessel filled
with clear water to reduce the risk of blockages.

FIRST USE

WARNING - RISK OF CHOKING:
not play with any packaging material of the appliance! Do not leave young children
without supervision with the appliance, any part of it, or the packaging in their reach.
WARNING - RISK OF BURNS:
ance get very hot. Additionally, the appliance is designed to give off hot water
and hot steam under high pressure. Always ensure to assemble the appliance com-
pletely and correctly before starting a brewing cycle. Always switch OFF (press the
power button), unplug and wait until the appliance cooled down, before cleaning
the appliance. Additionally, remove the drip tray and empty the water tank before
moving the appliance.
Always keep the workspace clean and dry. Do not pour or spill any liquids on or
under the appliance. Do not place clothes or similar materials on or under the appli-
ance during operation. If any liquid has been spilled on the appliance or ran into
the housing, immediately switch OFF (press the power button) and unplug the appli-
ance. Thereafter clean the appliance according to the instructions in chapter 'Care
and Cleaning'.
76
Always ensure that young children do
During operation, some parts of the appli-

BEFORE FIRST USE

1. Pull the appliance out of the box. Remove and discard all promotional labels,
stickers, and packaging materials attached to your espresso machine, but do
not remove the model label and serial number at the bottom of the appliance.
Always ensure that young children do not play with any parts or accessories
or the packaging!
2. Before discarding the packaging, ensure that you have found all parts and
accessories. See: 'Knowing Your EspressoAdvanced'. We recommend to store
the cleaning tool and filter basket not in use within the storage chamber. This
way these accessories will not get lost.
CAUTION: For removing the water tank, the water tank must be lifted straight
upwards. Do not attempt to tilt the water tank, when removing it to avoid damage
to the support of the water tank and the valves of the water tank and base of the
appliance. If required, press the housing of the appliance down with your thumbs,
while lifting the water tank up.
3. Ensure that the appliance is switched off. Then grasp the water tank at both sides
and pull it out vertically.
CAUTION: Do not use any abrasive cleaners, cleaning pads (e.g. metal scou-
ring pads), or any corrosive cleaners (e.g. disinfectants, chemical bleach) for clea-
ning. Do not use any hard or sharp-edged objects for cleaning the appliance. Do
not place the appliance or any part of it in an automatic dishwasher.
4. Clean water tank, cleaning tool, portafilter, filter baskets, and drip tray using
warm water and a gentle dish washing liquid. Rinse well with running tap water,
than dry thoroughly.
5. Place the appliance on an appropriate working place near a suitable wall
power outlet.
Note
Before each use, check the filling level of the water tank. We recommend to chan-
ge the water daily. Fill the water tank with cold, fresh tap water or low-mineral
bottled table water. Do not use mineral water, de-ionized water or other liquids
(see: 'Tips for Best Results / The Water Quality').
6. Assemble the drip tray with filling level indicator and cup tray and push the drip
tray into the base of the machine.
7. Insert the water filter into the water tank (see below: 'Inserting or Changing the
Water Filter'), fill the water tank, and slide down the water tank at the back of
77