EBECO EB-Therm 800 Handbuch Seite 68

Temperature, A and B
The thermostat uses external sensors that can be installed as
there are two sensors installed, it is possible to switch between
Moisture sensor, C
The thermostat uses moisture sensor C together with temperature sensor
A.
Delay
+HEATING
The delay can be set to ensure that the entire installation is free of snow
and ice before the thermostat is switched off. When the moisture sensor no
longer detects moisture, the thermostat will remain active for the set time,
before it switches off. The need for delay varies depending on the installation
and the location of the sensor.
A delay of up to four hours can be set, in intervals of 30 minutes. The factory
setting is zero.
Reset
RESET
There are three choices under the reset menu:
. The menu is under
SET RESET
Reset connection time
CONN TIME
The connection time is shown in hours; as with a vehicle trip meter, it shows
the number of hours an installation has been connected for since it was last
reset. This is beneficial if you want to calculate the energy consumption for
a certain period. The thermostat also has a counter that cannot be reset,
which shows the total hours the installation has been connected for.
To see the total and momentary connection times, press when the thermo-
stat is in display mode.
The reset function is in the
. This is preset to
CONN TIME
confirming with .
Reset the operation mode settings
Settings can be reset in
temperature and sensor settings return to the output values. Resetting does
not affect the choice of
The reset function is in the
. This is preset to
TIME NO
ing with .
CONN TIME
in the
SYSTEM MAIN MENU
menu under
SYSTEM
and is changed to
NO
OP MODE
. All programs are reset and the
OP MODE MAX/MIN
, or setting for
OP MODE LANGUAGE
menu under
SYSTEM RESET
and is changed to by pressing
YES
or . If
A B
, or
A B A & B
, and
OP MODE FAC
.
; from here, select
RESET
by pressing and
YES
.
DATE/TIME
, and there select
CONN
and confirm-
.
32