EBECO EB-Therm 800 Handbuch Seite 49

The temperature can be set between +5 °C and +45 °C. The thermostat works from
the temperature that is set in the manual program where the factory setting is +22
°C. If you change the temperature in the manual program, or the set point in the
TEMP menu, the thermostat works from the new temperature, and lowers the tem-
perature by +5 °C from the newly set temperature.
Holiday program HOLIDAY
This program is intended for saving energy and safeguarding against frost damage
in premises that are empty or unused for long periods, such as holiday homes and
storerooms, or unusually long periods of absence from home. The holiday program
can be controlled via a remote control unit. There are three menu alternatives to
choose between under HOLIDAY: ACTIVATE, CHANGE and RESET.
HOLIDAY is under PROGRAM in the MAIN MENU. The temperature can be set be-
tween +5 °C and +20 °C; the factory setting is +12 °C.
ACTIVATE
The program is started with ACTIVATE, and from there you can choose to use TIMER
SETTING. If you want to start the program without the timer function, select NO
and the program will then be active until another program is started. If you select
YES, the program will remain active for the selected time and will then return to the
previously used program.
The first time the program is used, the time and temperature must be set under
CHANGE. All the settings are saved in the memory and are not lost even if a
power cut occurs, but, in this case, the clock must be reset to obtain normal
functionality again.
CHANGE
To make changes to the settings, select CHANGE; TEMP is used to set the
temperature you want the thermostat to maintain when the program is activated,
TIMER is used to reset the current start and stop times; REMOTE is used to activate
remote control if applicable.
RESET
There is also a reset function, which resets the program to the factory setting, +12
°C, and deletes all the time settings.
REMOTE CONTROL
The holiday program can be controlled via a remote control unit. The unit is
connected to the applicable terminal block; see the wiring diagram. The holiday
program is activated when the remote control input is closed, and is deactivated
when it is opened again. The thermostat then returns to its previous setting.
13