EBECO EB-Therm 800 Handbuch Seite 50

Personal program [PERSONAL]
Manual setting of the program allows optimisation of energy consumption to suit
just your needs by making settings for four events each day: WAKE, AWAY, HOME
and NIGHT. There are three menu alternatives to choose between: ACTIVATE,
CHANGE and RESET.
The personal program PERSONAL is under PROGRAM in the MAIN MENU. The tem-
perature can be set between +5 °C and +45 °C; the factory setting is +22 °C.
ACTIVATE
The program is started with ACTIVATE and remains active until another program is
started. All the settings are saved in the memory and are not lost even if a power cut
occurs for a period longer than two days, but, in this case, the clock must be reset
to obtain normal functionality again.
CHANGE
To set your personal program go in under CHANGE. There are different ways of
setting the various events; you can choose to program day by day, weekend (Saturday
and Sunday) or the whole week. It is normally easiest to set the whole week first and
then adjust this for the days requiring a different setting.
When you have decided on the day(s) the event shall be set for, set the time of day
they shall occur at and the required floor temperature at that time.
Start by setting the time, which is blinking. Browse with the or the button to the
time you want the event WAKE to occur. First set hours, confirm with , then min-
. Browse to the required temperature for WAKE. Confirm with
utes, confirm with
and AWAY then shows. Repeat the steps above to set the time and temperature,
and HOME then shows. Repeat the steps above to set the time and temperature, and
NIGHT then shows. Repeat the steps above to set the time and temperature.
RESET
There is also a reset function, which resets the program to the factory setting, +22
°C, and deletes all the time settings.
Program for hotel environments HOTEL
This program allows you to control the heating via external card readers with a de-
lay time, since the thermostat has an integrated time relay function. The tempera-
ture settings change automatically when the hotel guest comes into or leaves the
room and the delay time is fully adjustable, making it easy to decide how long the
heating is to keep running after the guest has left the room.
The Hotel program can be found under PROGRAMS in the MAIN MENU. You select
HOTEL with . This displays the different settings that you can make in the pro-
gram. There are three settings to choose from: +HEAT, LOW TEMP and ACTIVATE.
14