EBECO EB-Therm 800 Handbuch Seite 47

Operation mode Heating
Heating mode is used in homes, offices, storerooms and such like.
With this operation mode, you can regulate the heating within a
temperature range of +5 °C to +45 °C. The thermostat can be used
as a floor thermostat, room thermostat or room thermostat with over
heating protection for wood floors. The energy saving program is
primarily adapted for home and office environments, but can also be
used for regulating heating levels in, for example, storerooms.
Main menu
MAIN MENU
contains three submenus:
MAIN MENU
returns you to display mode.
TEMP
TEMP
OH
PROTECTION
EXIT
Temperature menu
The temperature menu contains the functions that in some way concern
direct temperature regulation. This is where the set point and, if applicable,
over heating protection are set. The temperature menu is reached via
in the .
MAIN MENU
Set point
TEMP
The set point setting is under
quired temperature by pressing
set point can be set to an accuracy of 0.5 degrees within the range +5 °C to
+45 °C; it is preset to +22 °C.
Over heating protection
Over heating protection works as a floor temperature limiter; if you have a
wood or laminate floor, you must always use a room sensor with over heating
protection to ensure that the floor material is safeguarded against over
heating and damage.
Over heating protection is under
can be set between +5 °C and +45 °C. The factory setting is +35 °C, which
gives a surface temperature of about +27 °C.
,
TEMP PROGRAM
PROGRAM SYSTEM
MANUAL
LANGUAGE
HOME
DATE/TIME
OFFICE
S/W TIME
HOLIDAY SENSOR
PERSONAL ADAPTIVE
HOTEL
VENT
EXIT
RESET
EXIT
TEMP
in the temperature menu. Set the re-
TEMP
or and confirm by pressing
OH PROTECTION
OH PROTECTION
, and , which
SYSTEM EXIT
EXIT
DISPLAY MODE
TEMP
. The
under . The limitation
TEMP
11