Display Mode; Functions In Display Mode; Operation Mode; Main Menu - EBECO EB-Therm 800 Handbuch

Display mode

The display mode is the thermostat's "normal" mode; the most important
settings, statuses and functions are shown and set here. The display
shows, alternatingly, the set point and current values at the same time as
it always shows the operation mode and if the installation is switched on
or off. The set point is the desired value, whereas the current value is the
temperature or moisture status at this point in time.

OPERATION MODE

HEAT
PERSONAL
PROGRAM
TMP +20.0
IDLE
SET POINT
ON or OFF
* CURRENT VALUE A shows the temperature at sensor A and CURRENT VALUE B
shows the temperature at sensor B. CURRENT VALUE C shows whether moisture
is detected by sensor C. The current value is only shown for the sensors that are
installed and activated.
Functions in the display mode
The display mode contains six functions:
, shortcut to
TIME TEMP
.
STANDBY MODE
30 seconds after the last button press, the thermostat always returns to
display mode, irrespective of where in the menus you are. If you are ever
unsure of whether you are in the required menu or setting, you can always
let the thermostat return to display mode; no settings are then saved (if you
have not pressed to confirm), and you can start again from the beginning.
Overview
[press
To quickly and easily gain an overview of the thermostat settings, press
for three seconds to activate the overview function. You can then
use and
display mode, press

Main menu

[press
When the thermostat is in display mode, press
menu. From the main menu, you can reach all settings (read more
about the main menu under the section for the selected operation
mode). To return to the display mode, wait thirty seconds or
OVERVIEW
menu and set point, shortcut to
3 s]
to browse through the thermostat settings. To return to
or wait thirty seconds.
]
INTRODUCTION
SENSOR
RM 20.5
CURRENT VALUE A*
IDLE
CURRENT VALUE B*
CURRENT VALUE C*
, ,
MAIN MENU CONNECTION
menu and
LANGUAGE
to go to the main
EXIT
HEADING
ON or OFF
.
9