System Setting Menu - EBECO EB-Therm 800 Handbuch

To set your personal program, go in under . There are different ways
CHANGE
of setting the various events; you can choose to program day by day, week-
end (Saturday and Sunday) or the whole week. It is normally easiest to set
the whole week first and then adjust this for the days requiring a different
setting.
When you have decided on the day(s) the event shall be set for, set the time
of day they shall occur at and the required room temperature at that time.
Start by setting the time, which is blinking. Browse with the or the button
to the time you want the event to occur. First set hours, confirm with
WAKE
, then minutes, confirm with . Browse to the required temperature for
. Confirm with and then shows. Repeat the steps above to set
WAKE AWAY
the time and temperature, and then shows. Repeat the steps above to
HOME
set the time and temperature, and then shows. Repeat the steps above
NIGHT
to set the time and temperature.
RESET
There is also a reset function, which resets the program to the factory set-
ting, +22 °C, and deletes all the time settings.

System setting menu

SYSTEM
Under system settings, you will find settings for, for example, language and
date, as well as resetting functions for the time counter and for complete
resetting to factory settings. The system settings are under in the
SYSTEM
.
MAIN MENU
Language
LANGUAGE
You can choose between several languages; the factory setting is English.
Set the required language by scrolling through them using the or but-
ton and confirm with .
You can also use the shortcuts in the display mode (press for three sec-
onds). Then you go directly to the language menu. A practical function if
you, by mistake, set the wrong language and then have difficultly finding the
language menu again.
Date and time
DATE/TIME
A set time and date can be changed if needed, for example, if the electrical
supply to the thermostat was disrupted for a period of more than fifty hours.
The setting function then comes up automatically.
You will find date and time setting in the under and
MAIN MENU SYSTEM DATE/
. Change the value that blinks with either or and confirm with .
TIME
21