Introduction; Menu Navigation - EBECO EB-Therm 800 Handbuch

Menu navigation

The functions in EB Therm 800 are arranged in a system of menus and sub-
menus. The Main menu always contains three submenus
. There are further choices under these.
SYSTEM
The first time the thermostat is started, a number of requisite values must
be set in the START menu (see page 8). The START menu is then not shown
again: the thermostat always opens in display mode (see page 9).
The thermostat has two modes for background lighting, full and half strength.
If no buttons are pressed for 30 seconds, the background lighting reverts to
half strength. By pressing one of the three buttons, you can change to full
strength; the thermostat remains in display mode.
The menus are reached by pressing
The top row is always the name of the menu you are in. Use
the round marker; the marked line you are on blinks. Press
marked alternative. At the bottom of each menu there is an
turns you to the previous menu.
To reset the thermostat to factory settings, use the
you can read more about on page 16.
MARKER
MENU SELECTION
This button moves
you down in the
menus or reduces
values.
a second time in display mode.
START UP
LANGUAGE
DATE/TIME
MODE
This button opens This button moves
a new menu or you up in the menus
confirms a change. or increases values.

INTRODUCTION

, and
TEMP PROGRAM
or to move
to select the
, which re-
EXIT
function, which
RESET
MENU NAME
MARKED
SUBMENUS
BLINK
7