EBECO EB-Therm 800 Handbuch Seite 64

Reset RESET
There are three choices under the reset menu: CONN TIME, OP MODE and FAC
SET. The RESET menu is under SYSTEM in the MAIN MENU.
Reset connection time CONN TIME
The connection time is shown in hours; as with a vehicle trip meter, it shows the
number of hours an installation has been connected for since it was last reset. This
is beneficial if you want to calculate the energy consumption for a certain period.
The thermostat also has a counter that cannot be reset, which shows the total hours
the installation has been connected for.
To see the total and momentary connection times, press when the thermostat is in
display mode.
The reset function is in the SYSTEM menu under RESET; from here, select CONN
TIME. This is preset to NO and is changed to YES by pressing
with .
Reset the operation mode settings
Settings can be reset in OP MODE INDUSTRY. All programs are reset and the
temperature and sensor settings return to the output values. Resetting does not
affect the choice of OP MODE, LANGUAGE or setting for DATE/TIME.
The reset function is in the SYSTEM menu under RESET, and there select CONN
TIME. This is preset to NO and is changed to YES by pressing
with .
Reset factory settings FAC SET
The thermostat can be entirely reset to factory settings. All programmed data is
deleted and the start up menu is opened. If you choose to reset the thermostat, it is
important to know the operation mode it uses and the configuration of the sensors.
The only way to change operation mode is to reset to the factory settings.
The reset function is in the SYSTEM MENU under RESET; from here select
FACTORY SETTINGS. This is preset to NO and is changed to YES by pressing
and confirming with .
OP MODE
and confirming
and confirming
28