EBECO EB-Therm 800 Handbuch Seite 48

The surface temperature is an average value and varies somewhat depending on the
material and the thickness. Denser (harder) wood insulates less than softer wood,
which increases the surface temperature. Also, the thinner the floor, the higher the
surface temperature.
Two sensors are required for over heating protection: a room sensor (sensor A) and
an over heating protection sensor (sensor B).
Program menu PROGRAM
A smart way of saving energy is to adapt the heating to suit the needs throughout
the day and, for example, lower the temperature when there is nobody home. There
are four different ways of lowering the temperature: two preset programs for home
or office environments, one program for personal settings and a frost protection
program. There is no need to consider the heating time when programming since
the thermostat has an adaptive function that applies this automatically.
The programs are in the MAIN MENU under PROGRAM. To change program, browse
using or and select using . The manual program is the factory setting, i.e.
you set the required temperature (set point) and the thermostat maintains that
temperature.
Program for home environment HOME
The temperature is lowered automatically by 5 °C at the following times:
Monday–Friday 08:30–15:00 and every day between 23:00–05:00.
The home environment program is under PROGRAM in the MAIN MENU. Select
HOME using and a message is shown for two seconds to confirm that the pro-
gram has been activated. You can then see in display mode that the program is ac-
tive when HOME is shown on the second row.
The temperature can be set between +5 °C and +45 °C. The thermostat works from
the temperature that is set in the manual program where the factory setting is +22
°C. If you change the temperature in the manual program, or the set point in the
TEMP menu, the thermostat works from the new temperature, and lowers the tem-
perature by +5 °C from the newly set temperature.
Program for office environment OFFICE
The temperature is lowered automatically by 5 °C apart from at the following times:
Monday–Friday 06:00–18:00.
The office environment program is under PROGRAM in the MAIN MENU. Select
OFFICE using and a message is shown for two seconds to confirm that the pro-
gram has been activated. You can then see in display mode that the program is ac-
tive when OFFICE is shown on the second row.
12