EBECO EB-Therm 800 Handbuch Seite 59

Reset connection time
CONN TIME
The connection time is shown in hours; as with a vehicle trip meter, it shows
the number of hours an installation has been connected for since it was last
reset. This is beneficial if you want to calculate the energy consumption for
a certain period. The thermostat also has a counter that cannot be reset,
which shows the total hours the installation has been connected for.
To see the total and momentary connection times, press when the thermo-
stat is in display mode.
The reset function is in the
. This is preset to
CONN TIME
confirming with .
Reset the operation mode settings
The settings can be reset in
temperature and sensor settings return to the output values. Resetting does
not affect the choice of
The reset function is in the
. This is preset to
TIME NO
ing with .
Reset factory settings
FAC SET
The thermostat can be entirely reset to factory settings. All programmed
data is deleted and the start up menu is opened. If you choose to reset the
thermostat, it is important to know the operation mode it uses and the con-
figuration of the sensors.
The only way to change operation mode is to reset to the factory settings.
The reset function is in the
. This is preset to
FACTORY SETTINGS
and confirming with
menu under
SYSTEM
and is changed to
NO
OP MODE
. All programs are reset and the
OP MODE COOLING
, or setting for
OP MODE LANGUAGE
menu under
SYSTEM
and is changed to
YES
under
SYSTEM MENU
and is changed to
NO
.
; from here, select
RESET
by pressing
YES
.
DATE/TIME
, and there select
RESET
by pressing and confirm-
; from here select
RESET
by pressing
YES
and
CONN
23