System Setting Menu - EBECO EB-Therm 800 Handbuch

Connection time
[press
To see the total and momentary connection times*, press
thermostat is in display mode. The counter shows the total hours the
thermo stat has been connected for as well as the momentary time,
in the same way as a vehicle trip meter, i.e. the number of hours the
installation has been connected for since the counter was reset. The
connection time is used to calculate the energy consumption** of the
installation.
The momentary counter is reset in the
; both counters are reset if the thermostat is reset to factory
COUNTER
settings. To return to display mode, press
*Connection time = the time that the thermostat has been activated, i.e.
how long the heating or cooling installation has been connected for.
**Energy consumption (kWh) = Installed effect (kW) x Connection time (h)
Shortcut to language setting
To change the language setting without going through the menu
system, press
come directly to the language menu (read more about the language
menu under the section concerning the selected operation mode).
Shortcut to temperature setting
To quickly change the temperature setting without going through the
main menu, go to display mode and press
takes you directly to temperature setting (set point).
Standby mode
[press
When the thermostat is in standby mode, the temperature is not regu-
lated and the screen is inactive, but the clock runs as usual and all the
settings are stored in the memory. Note that the thermostat is still
supplied with electricity.
Standby mode is set from the display mode by pressing
seconds; you are then asked if you want to switch off the thermostat.
If you select standby mode is activated; if you select
YES
thirty seconds) the thermostat returns to display mode. To exit standby
mode, press any button. This will return you to display mode.
Now we have gone through everything that is required to go directly to the
operation mode you will use in the thermostat. There, you can read more
about all the functions and how to set them to get the most out of your
thermostat.
]
SYSTEM MENU
[press 3 s]
when the thermostat is in display mode. Then you
[press 3 s]
3 s]
INTRODUCTION
when the
under and
RESET
or wait thirty seconds.
for three seconds; this
for three
(or wait
NO
10