EBECO EB-Therm 800 Handbuch Seite 52

Date and time DATE/TIME
A set time and date can be changed if needed, for example, if the electrical supply
to the thermostat was disrupted for a period of more than fifty hours. The setting
function then comes up automatically.
You will find date and time setting in the MAIN MENU under SYSTEM and DATE/
TIME. Change the value that blinks with either
Summer and winter time
The thermostat calendar and clock are automatically set to summer and winter time
but the function can, if it is not required, be switched off.
Summer and winter settings are in the MAIN MENU under SYSTEM; select S/W
TIME. Switch off the function under ON/OFF in the menu and select OFF, a mes-
sage is shown for a short time confirming that the function is switched off. Activate
the function in the opposite way by selecting ON.
Sensor settings SENSOR
The thermostat can regulate temperature in three ways to accommodate both com-
fort temperature and possible temperature requirement for floor material.
The sensor settings are in the SYSTEM menu under SENSOR, and there select the
sensor you want to use by browsing with
Adaptive function ADAPTIVE
The thermostat has a function that calculates when heating should be started to
provide the required temperature at the right time. The function is activated on
delivery, but can be switched off as required.
You will find the settings for adaptive function in the MAIN MENU under SYSTEM,
and there you select ADAPTIVE. Switch off the function under ON/OFF in the menu
and select OFF, a message is shown for a short time confirming that the function is
switched off. Activate the function in the opposite way by selecting ON.
Ventilation mode VENT
If the room temperature sinks by more than 3 °C in a minute, for example, when
airing, ventilation mode is activated. The thermostat then deactivates heating for
15 minutes, after which it returns to the same setting; ventilation mode shows in
the display when it is activated. The function is activated on delivery, but can be
switched off as required.
You will find the settings for adaptive function in the MAIN MENU under SYSTEM,
and there you select ADAPTIVE. Switch off the function under ON/OFF in the menu
and select OFF, a message is swhown for a short time confirming that the function
is switched off. Activate the function in the opposite way by selecting ON.
FLOOR THERMOSTAT
The most common installation that suits most rooms and needs. A sensor placed in
the floor measures the temperature and regulates the heating.
Note that the sensor measures the temperature below the surface; if the
or
S/W TIME
or and confirm with
and confirm with .
.
16