Program Menu - EBECO EB-Therm 800 Handbuch

Set the required max temperature by pressing or and confirm with
, then set the required min temperature in the same way. The values can be
set with an accuracy of 0.5 degrees, and the factory settings are max +2 °C
and min -10 °C. Both max and min temperatures can be set between +10 °C
and -20 °C.
Two sensors can be installed on the thermostat. If two sensors are used
simultaneously, the temperature must be within the set range for both
sensors for the thermostat to be activated.

Program menu

PROGRAM
In Operation mode , there is a timer program that makes it possible
MAX/MIN
to customise snow melting further in order to save energy.
You will find under in .
TIMER PROGRAM MAIN MENU
Timer
TIMER
A smart way of saving energy is to adapt snow melting to your needs over a
24-hour period. Up to four on and off switchings can be programmed in the
timer program, i.e. it will only be active during certain periods of the day or
during certain days. There are three menu alternatives to choose between:
, and .
ACTIVATE EVENTS RESET
The function is under in the . To start the timer
TIMER PROGRAM MAIN MENU
program, select and then ; to switch off the timer, select When
TIMER ON OFF.
or have been selected, a message is shown for two seconds confirm-
OFF ON
ing that the function has been activated or deactivated. In the factory set-
tings, the temperature alarm is deactivated.
ACTIVATE
The program is started with the activate function, and it remains active until
another program is started. The first time the program is run, the times must
be set under . All the settings are saved in the memory and are not
EVENTS
lost even if a power cut occurs, but, in this case, the clock must be reset to
obtain normal functionality again.
EVENTS
To set the program, go to or . There are different ways of
TIMER CHANGE EVENTS
setting the various program events: you can choose to program day by day,
weekend (Saturday and Sunday) or the whole week. It is normally easiest to
set the whole week first and then adjust this for the days requiring a different
setting.
When you have selected the day(s), set the number of events (max 4) and
the times during the day they shall occur. Browse with the or button
to change the number events, and confirm using .
To set an event, start by setting the time, which is blinking. Browse with
the or the button to the time you want the event to occur. First
ON
set hours, confirm with , then minutes, confirm with . Repeat the
steps above to set .
OFF
30