Commissioning the Mover®
Ensure the battery used to operate the Mover® is fully
charged.
Park the caravan outside on an open, level surface and apply
the handbrake. Ensure that the rollers are disengaged from
the road tyres and the corner steadies are raised.
Connect battery terminals to battery, check that all cables are
secure and not hot or indicating signs of short circuits, etc.
Plug the 13-pin plug into the safety socket.
If there is a fault in both caravan brake lights, the power
circuit of the safety socket is not closed. In this case the
Mover® cannot be operated.
Move slide switch on remote hand set to the "On"
This switches on the remote control, the green LED flashes in
combination with the signal tone approx. 5 seconds until both
control systems are operational. If LED does not illuminate,
check polarity and condition of batteries in remote hand set.
The remote hand set switches itself off after about 2 minutes
if no buttons are pressed.
Check whether all 4 drive motors are standing. If the remote
control is switched on, press the forwards button; all 4 drive
motors now need to move in the forward direction.
Engage the drive rollers against the tyres by using the remote
hand set.
Please ensure that there are no obstructions beneath the cara-
van, then release the handbrake. Now check all functionality
as per the operating instructions.
Apply caravan handbrake. Disengage the drive rollers and
move slide switch on remote hand set to the "Off" £ position
to switch the remote hand set and the Mover® off. Re-check
distance between drive rollers and tyres. Adjust if necessary.
The distance between the disengaged drive rollers and
the tyres is 20 mm.
Warning information
The yellow sticker with the warning information, which is
enclosed with the appliance, must be affixed by the installer
or vehicle owner to a place in the vehicle where it is clearly
visible to all users (e.g. on the wardrobe door)! Ask Truma to
send you a sticker, if necessary.
24
❙
position.