Connecting The Battery; Functional Testing; Warning Notes - Truma Mover smart A Einbauanweisung

– Push rubber protective caps onto connection screws.
Figure 37

Connecting the battery

Incorrect connection of the battery will lead to a defect
in the control unit.
Connect the fuse in the positive line (125 A) near the
positive terminal.
Liquid electrolyte batteries must be assembled in a separate
box with ventilation facing outwards. The fuse in the positive
line must be connected outside the box. A separate box is not
required for gel and AGM batteries. Observe the installation
requirements of the battery manufacturer.
The battery connector cables must be laid separately until
after the fuse in the positive line.
-
+
Figure 38
Route the battery connector cables (only use the Truma
original cables included in the scope of delivery) to the control
unit and firmly secure using the supplied clips and screws.
The battery connector cables must not be extended.
They must be routed separate from the motor cables
and must not run over the control unit.
Route the battery connector cables such that they cannot
rub (particularly at lead-throughs in metal walls). Use suitable
lead-through bushings to protect the cables from being
damaged. Connect the battery connector cables at the battery
terminals present (red = positive, black = negative).
EN
20
- +

Functional testing

Failure to carry out functional testing can result in
serious injury and damage to property.
Only specialist personnel may carry out functional
testing.
– Pair up the remote control and control unit in accordance
with the operating instructions.
– Check that the battery for operating the Mover is fully
charged.
– Park the caravan outside on open, level ground and apply
the parking brake or secure against rolling away.
The drive rollers must not be in contact with the wheels
and the corner supports must be raised.
– Connect the battery terminals to the battery.
– Check that all cables are firmly secure and not hot and that
there are no signs of short circuit etc.
– Supply the Mover with power via the battery cut-off switch.
– Switch on the remote control.
– Check whether both drive motors are off.
– With the remote control switched on, press the "up arrow"
within a distance of 2 m of the control unit; both drive
rollers must now turn forwards.
– Engage the drive rollers (see operating instructions)
– Make sure that there are no obstacles around the caravan,
release the parking brake or remove the anti-roll stopper
and switch on the remote control.
– Check all functions several times in accordance with
the operating instructions.
– Apply the caravan's parking brake or secure against
rolling away.
– Decommission the Mover in accordance with the operating
instructions.
– Check the distance between the roller and the tyre again.
Readjust if necessary.
The distance between disengaged drive rollers
and tyres is 20 mm.

Warning notes

The yellow stickers bearing warning notes that are supplied
with the device must be installed by the installer or vehicle
owner in a location in the vehicle that is clearly visible for all
users (e.g. on the wardrobe door)! Missing stickers can be
requested from Truma.