Safety; Symbols Used; Warnings; Notes On Ce Identification - MICRO-EPSILON combiSENSOR KSH5 Betriebsanleitung

Safety

combiSENSOR
All manuals and user guides at all-guides.com
1. Safety
Knowledge of the operating instructions is a prerequisite for equipment operation.
1.1

Symbols Used

The following symbols are used in this instruction manual:
Indicates a hazardous situation which, if not avoided,
may result in minor or moderate injury.
Indicates a situation which, if not avoided, may leed to
property damage.
Indicates a user action.
i
Indicates a user tip.
1.2

Warnings

Disconnect the power supply before touching the sensor surface.
> Danger of injury through static discharge
The power supply and the display/output device must be connected in accordance with the
safety regulations for electrical equipment.
> Danger of injury
> Damage to or destruction of the sensor and/or controller
The power supply may not exceed the specified limits.
> Damage to or destruction of the sensor and/or controller
Avoid banging and knocking the sensor and controller.
> Damage to or destruction of the sensor and/or controller
Protect the cable against damage.
> Failure of the measuring device
1.3

Notes on CE Identification

The following applies to the measuring system: EMC regulation 2004/108/EC
Products which carry the CE mark satisfy the requirements of the EMC regulation
2004/108/EC 'Electromagnetic Compatibility' and the European standards (EN) listed ther-
ein.
The EC declaration of conformity is kept available according to EC regulation, article 10 by
the authorities responsible at
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Koenigbacher Straße 15
D-94496 Ortenburg
The system is designed for use in industry and satisfy the requirements of the standards
- EN 55011: 2007 + A2: 2007
- EN 61 000-6-2: 2005
The systems satisfies the requirements if they comply with the regulations described in the
instruction manual for installation and operation.
Page 29