Create A Test Mail Set - FP FPi 6600-2 Betriebsanleitung

Create a Test Mail Set

Before starting an existing job or a new, manual created job, it is possible to create a test
mail set.
This test run is intended to validate the settings of the Inserting System:
• Check if the address is correctly positioned behind the envelope window.
See Adjusting the Address position
• Inspect and adjust the stop position of the envelope. See
Insert fingers on page 37.
• Check the fold settings for one set. See
When you tap the [1x] button, you can choose between three test mail sets:
• Selected exit: creates one mail set that leaves the system at the defined exit. Use
this option to test the complete process.
• Present on deck: creates one mail set without sealing. The mail set leaves the system
from the upper unit. Use this option to verify and adjust the address position.
• Envelope stop position: separates one envelope and transports the envelope to the
envelope stop position. Use this option to verify and adjust the envelope stop position.
on page 36.
Fold settings on page 28.
Adjusting the Envelope
3
35