Operator Troubleshooting - FP FPi 6600-2 Betriebsanleitung

2. Remove the documents. If necessary open the feed unit:
- Place your hand on the push down area F.
- Push down the release handle E.
3. Remove the documents from the transportation area and from the rear side of the
10
separation rollers.
4. Close the feed unit:
- Place your hand on the push down area F.
- Push the feed unit down until it locks into place.
5. Place release handle D of the separation unit in the closed position.
6. Tap [x] of the error message at the inserter to reset the error and restart the job.

Operator Troubleshooting

To resolve problems:
1. Write down the event message number that is shown in the message on the screen.
2. Try to solve the problem by consulting the
3. Switch the inserter off and on again, to verify system operation.
4. When the error still occurs contact your service organization.
136
When contacting the service organization, you will also be asked
for the last error message and the software package version of the
installed software. To determine the software package version,
see Software overview
Troubleshooting Table
on page 79.
on page 137.