Create A Test Mail Set - FP FPi 4700 Betriebsanleitung

Finish the Job Definition and Start the Job
When you have finished the exit settings, the touch screen shows an overview of the job
settings.
In this screen you can change the following settings:
• Move documents between feeders (see
3
• Link feeders (see
• Change the counter settings (see
When you are ready with these settings, proceed as follows:
1. Load the documents
2. Tap [1x] to create a test mail set (see
3. If desired, you can save the job (see
4. Tap [Start] to start the job.

Create a Test Mail Set

Before starting an existing job or a new, manual created job, it is possible to create a test
mail set.
This test run is intended to validate the settings of the Inserting System:
• Check if the address is correctly positioned behind the envelope window.
See Adjusting the Address
• Inspect and adjust the stop position of the envelope. See
Insert fingers.
• Check the fold settings for one set. See
28
Link feeder trays)
Change the counter
on page 45 as indicated on the Job info screen.
Test mail
Save a
position.
Change to an other feeder
settings)
set).
job).
Adjusting the Envelope
Fold settings.
tray)