Operator Troubleshooting; Startup Problems - FP FPi 600 Betriebsanleitung

6.2.4 Envelope
Hopper
When a stoppage occurs
in the envelope hopper,
remove the envelopes as
follows:
1. Press the
to open the system.
2. Remove the envelope.
If this is not possible, try
to remove it from the top
of the hopper:
1. Close the system.
2. Remove the envelope
stack and remove the
envelope.
6.3

Operator Troubleshooting

To solve problems:
1. Write down the error.
2. Consult the troubleshooting tables in sections 6.3.1 up to 6.3.5 to solve the problem.
3. Switch the system off and on again, to verify system operation.
4. When the error still occurs contact your service organization.
Note
When contacting the service organization, you will also be asked for the last error
message.
6.3.1

Startup Problems

Symptom
The system
cannot be started
after switching
on.
22
button
Possible cause
System not
connected to mains.
You switched off the
system accidentally.
You did not press the
power button next to
the touch screen.
A cover is opened.
Remedy
Connect the system
to the mains.
Switch the system
on.
Press the power
button next to the
touch screen.
Close the covers.
Reference
-
-
-